ExtremeCloud IQ- Site Engine Management Center - Page 213 - Extreme Networks

ExtremeCloud IQ- Site Engine Management Center

Questions and discussions about ExtremeCloud IQ-Site Engine Management Center

Forum Posts

Sorted by:

Start a conversation

XMC - System Variables

Hello, there are a lot of system variables in XMC for scripting. I test some of the variables with python on XMC together with an xos switch. All works fine. But the variable $STATUS returns always 1 no matter the command works or not. Here is the...

Set policy profile as port description

Hi Folks, we are using NetSight Port Profiles to assign VIDs and ACLs to certain switch ports. Is there any way to set the name of port profile (show policy profile) as port alias / description via UPM Script? Anyone did something similar in the pa...

XMC Device Type Visibility

Hi Community. With the Version 10 of the Identify wireless firmware, it identifies device types, without the need for NAC. Can XMC report on the device types ect without NAC, reading this information from the wireless controller?

Is it possible to collect NetFlow from a Cisco 6513 using NetSight?

I am now, sadly, managing an all-Cisco network, with no management system. I'm testing NetSight, to see if it will integrate with our Cisco switches and routers. I've used NetSight successfully on two large Enterasys LANs for the last eight years, ...

PV-FC-180 GRE tunnel config problem

Hello the Hub ! I need to configure PV-FC-180 to send analitycs data to PV Appliance. I want to have a single interface configuration, where I am using two tg.1.2 and tg.1.4 interfaces configured as lag.0.1 and connected to MLAG core. tg.1.1 is whe...

Top Kudoed Authors

User

Count

81

75

39

17

16

GTM-P2G8KFN