Run a workflow in XCC without selecting the device
Hi,I want to run a workflow(some show commands) in XCC without selecting the XCC(automatic) and I want to schedule the task.
Forum Posts
Resolved! Integration between NetSight (Extreme Management Center) and Third Party NMS Software
Hi I need to integrate network devices information info into a 3rd party NMS (WhatUp Gold) Can NetSight export network information info? how?Is that possible using SNMPv3? Also, is it possible to configure NetSight to forward SNMP Traps to another NM...
Set alarms for logicl port status
Good afternoon all;Short question. How can I display status information / receive notifications for logical ports displayed in XMC 8.5The devices I am querying are Actelis DSL devices.Thank you for your input.Kind Regards;Ingo
Updating Fails on Delta updates
I have an AP305 in a pilot configuration while I build my Cloud IQ wlan. I have noticed that every time I try a delta update the update fails. Complete updates succeed.In the threads here I saw that clock offset was a potential cause, and I have ma...
Cloud IQ with Site Engine based NAC - AP location syntax for location based vlans
We are building a new wireless setup using XCloud IQ and XCSE based NAC. In the past I have created zones in the Indentifi controller for my buildings, and when onboarding my APs I assign them to zones.In Cloud-IQ I see locations using this type of ...
