Ive got a switch where adding a few security cameras goes over the poe capacity.I notice the AP250s connected to this switch all are running as 802AT and I want to change them down to AfI can't seem to find anyway to do this Found this cli mode comma...
I apologize for the newbie question but I can't seem to find an answer to this question - I suspect it it too obvious. On an AP460C or an AP510C, can I configure a secondary port so that I can connect a wired device to it? In essence use the access p...
Good Morning All,New to this forum and this product line as of recently as we are an MSP that has a client that has purchased a fair amount of equipment with extreme. They have:(4) XCCORC-P-25 Extreme Campus Controllers(4) AP460C-FCC Aerohive Outdoor...
Hi,This is about the 3rd or 4th time this has happened, but ill go into Manager >> Planning and some of the buildings ive placed over the satellite picture are no longer there... some are not even in the same state.The one circled in red is correct, ...
Hi experts,At my customer the Access Points 550/410c have to connect to the internet via a proxy so that they can register on the XIQ.Unfortunately the proxy has to be entered via the Console CLI in the CAPWAP Config.CAPWAP Client HTTP Proxy name xxx...
