4 weeks ago
I've spent a few months developing a few virtual AP device configurations (and all the policies, etc.) in XIQ. I'm finally almost ready to onboard the physical AP device(s), but have a question: When I onboard the physical device, does the virtual device go away, or will I end up with both the onboarded physical device and the virtual device?
Also, is there a way to exactly copy all the attributes of a virtual device into another one in one step, with just the necessity to change the name/ID? I'd like to keep my original virtual configurations as reference.
Does this make sense? Thanks... 🤔
Solved! Go to Solution.
3 weeks ago
Hello @gnar13,
Virtual APs will not be deleted or removed when importing real devices. You can test this by importing a real device (without actually connecting one).
When you create configurations you are actually creating objects which are stored in the main object container (Configure > Common Objects) and those can be used by any AP that supports these settings. If you delete an object from the Network Policy, you are simply removing it from said Network Policy and not completely deleting it since it still exists in the main object container.
You will have to build an AP template for the real APs and add the objects therein (but those should have been already configured so all you have to do is select and add them to the template)
I hope this helps,
BR,
3 weeks ago
Hello @gnar13,
Virtual APs will not be deleted or removed when importing real devices. You can test this by importing a real device (without actually connecting one).
When you create configurations you are actually creating objects which are stored in the main object container (Configure > Common Objects) and those can be used by any AP that supports these settings. If you delete an object from the Network Policy, you are simply removing it from said Network Policy and not completely deleting it since it still exists in the main object container.
You will have to build an AP template for the real APs and add the objects therein (but those should have been already configured so all you have to do is select and add them to the template)
I hope this helps,
BR,
3 weeks ago
Hi Christoph_S,
That's exactly the information and detail I was looking for. 🙂 Thanks.
Regarding the AP template... Is it possible to save an existing virtual AP device configuration as a new template? From what I've seen when importing the real devices earlier today (and your comment near your last paragraph) it's not possible and must be built from scratch. Did I get that right?
Best regards,
gnar13
3 weeks ago
Hello @gnar13,
The same template can be used by real and simulated APs, so if you create a template for example for an AP460C simulated AP, you can use the same template for a real device.
I hope this helps,
BR,
2 weeks ago
Hi Christoph_S,
Thanks again.
Well... In learning the XIQ system, I had a hard time dealing with network profiles, "common objects," templates and the like. What I intuitively already understood, was managing device configurations. Long story made short(er): since I only get 2 network profiles, I used the default templates for each AP and didn't associate a default or custom template with a profile. The slight anticipated changes to each configuration (at the time) didn't warrant fully figuring out the templates, but now I wish I had. In general, I also have a hard time navigating to setup a specific feature. (If you asked me right now how to create a custom template, I wouldn't know where to begin, and I've read through so many pages of the XIQ manual...)
Best regards,
gnar13