Will the configuration copy over to the replacement blade once the chassis sees the new blade. Or will I have to redo the config for the replaced blade, in a bonded situation.
given the following configuration:
D2(su)->show cos state
Class-of-Service application is enabled
D2(su)->show cos settings
CoS Index Priority ToS IRL flood-ctrl
--------- ---------- ------- ------- ----------
0 0 ...
Hi,I am trying to find the cause of a network problem in one of our buildings. We have one C5 and 6 A4-48 port switches there. C5 is set as router and all A4s are access switches and connected to C5 directly.The problem is; on 4 of the A4 switches th...
Ladies and Gentlemen,
I have a network setup with several hundred Enterasys switches, ranging from D series all the way up to the S series. Because of the physical topology, we've been content with using the default settings for MST, and using the...
I want to define two entries in my routing table with static routes.
Destination Gateway
----------------------------
10.0.0.0/8 172.17.1.1
10.9.184.0/22 172.17.2.1
How makes a decision about packet forwarding?
I know that in Cisco Router...
