ExtremeSwitching (EOS) - Page 68 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

7100-Series / ACL / Access Control List Limitations

We try to transfer an ACL from a DFE module (with Advanced Licence) to an 7100 (about 300 entries). We can only enter 180 lines, then we're done. TOR(rw-cfg-ext-acl-160)->permit tcp host 192.168.60.254 any eq 2222 Apply access-group failed: Insuffic...

Port channel between Server and Extreme Summit Switch

I need to setup a port channel between two VMware environment and extreme summit switch X460. I have try to configure this and it break the connection on extreme but when I move back the cables to cisco everything is working fine. I want...

Tagged and untagged traffic in same VLAN on same port

Hey, Is it possible to have tagged and untagged egress on a single port and in the same VLAN? Apparently not. (The switch sets either tagged or untagged egress.) Is there a workaround? (like assigning the VLAN once untagged and once tagged to a fix...

How to migrate configuration from EOS to EXOS??

I need to configure my x440-g2 with exos to use in my network. all switches that i have are c5 and b5 witch eos ... now i need to translate eos config file to exos.... and this is my base config to migrate: set ip address 172.16.0.XXX mask 255.255....

7100 series LACP ports not dormant after connecting to server NIC team

Hi, We are trying to configure a lag on a 7100 series switch. We have good experience with creating lags between switches, and ESXi hosts. However, this is the first time we have done this using Microsoft 2012 R2 NIC teaming. On the server, I ...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN