ExtremeSwitching (EOS) - Page 86 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

B2G124-24 hpcBroadInit:1008, could not find the board

Hello. I changed CR battery and update firmware on B2G124-24. But i have cyclic reboot my switch and this message sysconf_attach: bcm device init failed soc_init: unit 2 not attached system_init: Device reset failed: Invalid unit In hpcBroadInit:10...

Is 802.3az supported on the C5 ?

Hi, my first post to TheHub. Apologies for newbie mistakes... I would like to confirm that the C5 stackable switches DO NOT have 802.3az support. There is no mention of it I can find in the documentation, so I am assuming this is the case. I hav...

Howto add multiple VLAN over MPLS VPLS connection

Hello, Is it possible to create multiple VLAN over my MPLS VPLS over VMAN. My end to end connection between my two peer are now established. What should I do to have my VLAN at my other end pass through over my MPLS. Thank you in advance.

QSFP+ LR4 Parallel Single Mode transceiver

Installing a QSFP+ LR4 Parallel Single Mode transceiver. I had set one of the fg.1.1 to 10GB creating 4 tg ports. In order to use these transceiver, do I set the port back to 40GB?

C5 6.81.07.4 IGMP configuration

Dear all, The firmware version 6.81.07.4 for C5 now includes the command set igmp enable (before only available for the K/S). This command replaces the following 2 commands required for the old firmware versions ? set igmpsnooping interfacemode...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN