ExtremeSwitching (EOS) - Page 85 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

L2GRE support On Extreme Switches

I need to know does Extreme E8 series switch supports L2GRE or Ethernet Over GRE. If i can terminate GRE tunnels on this switch, how many L2GRE tunnels can be terminated on this switch which can act like L2GRE concenterator

XSR Seems to Freeze

I have an enterasys XSR-3150 with firmware :7.6.14.0002. Sometimes my internet connectivity goes off and I have traced and realized its the router. I am able to ping and console to verify all my configs and everything seems fine but until I always ...

B2G124-24 hpcBroadInit:1008, could not find the board

Hello. I changed CR battery and update firmware on B2G124-24. But i have cyclic reboot my switch and this message sysconf_attach: bcm device init failed soc_init: unit 2 not attached system_init: Device reset failed: Invalid unit In hpcBroadInit:10...

Is 802.3az supported on the C5 ?

Hi, my first post to TheHub. Apologies for newbie mistakes... I would like to confirm that the C5 stackable switches DO NOT have 802.3az support. There is no mention of it I can find in the documentation, so I am assuming this is the case. I hav...

Howto add multiple VLAN over MPLS VPLS connection

Hello, Is it possible to create multiple VLAN over my MPLS VPLS over VMAN. My end to end connection between my two peer are now established. What should I do to have my VLAN at my other end pass through over my MPLS. Thank you in advance.

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN