ExtremeSwitching (EOS) - Page 95 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

How to configure XOS to use EOS default spanning tree configuration

I have worked with EOS for several years without any spanning tree problem, I would like to know how to mimic the default spanning tree setting in EOS on an XOS device(i.e. what commands would I need to use to have XOS stp work just like EOS stp?)

vlan configuration for routing unable to ping own subnet

Hi guys, First of all, I'm really new to this and have been stumbling through to figure out a nagging issue We created 4 VLANs with corresponding Virtual Routers (as well as separate subnets) in our brand new environment (Users,Server, Lab,Phone). ...

Question about "A" Model Transition in S-Series

Dear all. It´s about the "A" Model Transition in S-Series. I have some questions about the technical behavior in case of a service/incident. Is it possible to - replace a “A” with a “non-A” Model when MACSec is enabled...

Why numerous ARP's from 0.0.0.0 or 169.X.X.X

S4 cores show repeated messages--(approx.5-10/sec) of "Recieved ARP on vlan XXXX but there is no path to the sender IP address 0.0.0.0 (or 169.x.x.x )" Campus environment with 5000+ pc's Is this normal behavior of MS pc's when they boot before they...

routing between vlan on B5 (ip routing command)

Dear, I Have on Enterasys B5G124624 switch, (FW: 06.71.03.0025, HW : BCM56514 REV 1, Bp : 02.02.51), when I enable routing inter vlan, using command ip routing, the switch accept command,, but I don't see it in configuration ( output of command s...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN