ExtremeSwitching (EXOS/Switch Engine) - Page 100 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Stack link blocking election

I have a stack in a ring topology with 5 x460g2-48t-4ge10 and the link between stack-ports 3:2 and 4:1 looks to be bad. I have already changed cables, etc to bring it down to being just one of the ports flapping. I have rearranged the stack to go 1-2...

Troubleshoot an RDP ACL

Hello All,I am trying to create an ACL where certain subnets can RDP "port 3389" into a different subnet's hosts. While other devices can't RDP to that certain subnet. I am pasting the ACL, I have created. Basically, 10.8.7.X subnet should be able to...

Remove meter on X440-8

Set this up so long ago and lost my notes. Trying to either update or remove the meters on a few ports. Removing would probably be fine. This is the internet switch and was in place when there was only a 100mbit connection, now it's 1Gbit, so these r...

Resolved! VRRP with IPV4 and IPv6

Hi guysI have a VRPP config for IPv4 addressing, which it is working. I need to config a VRRP IPv6 addressing with the same vlan (same vrid).But i get the following error:* SW1 # config vrrp "vlan" vrid 9 add 2001:db8:0:9::1 Error: Specified IP addr...

EAPS With CFM Example

I looked in the XOS User Guide to get some idea of how to properly configure EAPS with CFM, but the section on "Configuring EAPS with CFM Support" really looks to not have much content. I found a discussion thread about it, but for some reason the p...

Top Kudoed Authors

User

Count

32

28

20

20

17

GTM-P2G8KFN