ExtremeSwitching (EXOS/Switch Engine) - Page 118 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Is there an EXOS equivalent to Cisco DTP?

Is there a way to disable Dynamic Trunking Protocol in EXOS? I plugged in a switch for initial config to a port that had some vlans tagged and one that is untagged. The port on the new switch dynamically set the port to have those vlans tagged. I am ...

Resolved! Unable to remove application-priority under access-list zone (default priority unknown application) – Module acl configurations

Hello Everyone,I am unable to remove configurations under access-list zone application priority for specific applications, i checked the topic How to remove application access-list under system zone that is seen under "show configuration acl" output?...

Resolved! Port mirroring limitation for X440 and X460 Series

Hello, I am trying to get information about port mirroring limitations in X440-G2 and X460-G2 series switches. Also, is there differences between models (12, 24, 48 ports)? Thanks Andrea

Resolved! General MSTP and ELRP question

I am just starting to put my toes in the pool that is Extreme Networks and I am getting some conflicting information about Multi Spanning Tree and the Extreme Loop Recovery Protocol…I was under the knowledge that ELRP was an option to enable in a MST...

Resolved! Firmware for 200-48 , some help?

Im need firmware 200-48 in this site is impossible found , can help me link for download? tks1

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN