ExtremeSwitching (EXOS/Switch Engine) - Page 162 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

config ntp server on 15.1.2.12 670-48p-10g

Command Ref (http://extrcdn.extremenetworks.com/wp-content/uploads/2014/02/EXOSCommandRef_15.1_Version4.pdf) says "configure ntp [server | peer] add [ | ] {key } {option [burst | initial-burst]}" 670-48p-10g does not recognize "sh ntp" or "config nt...

Telnet from old summit200 to a summitX440-G4

Good morning, Probably a dumb question, but, why can’t I telnet to a summitx440-g4 from a summit200? Summit200 running Extremeware Version 7.8e.4.1summitx440-g4 EXOS 22.7.1.2-patch1-17 Thanks

Resolved! password recovery fails from Bootrom

Good Morning,I have several Switch Models X44024-t. I need to recover the password of these guys but I can't perform a hard reset because I don't know how the settings are and I can't reset the password because in the bootrom the command config none ...

Resolved! Important to MLAG using all unique ethernet port numbers on each MLAG peer switch?

Hi All,I am setting up a pair of EXOS switches as MLAG peers to provide redundant connectivity to stacked switches in our IDF closets. I have been referencing the EXOS User Guide along with some other GTAC articles. In one titled, “Key Design Points ...

Resolved! ACL on G2 to only allow one IP address to connect

I need to restrict access to my IP cameras from one IP which is 10.10.10.104/24I have 8 IP cameras and I’m just trying to get this working with one for now.I have the following to allow it and that obviously works, but I cant figure out the else if/e...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN