Hi all, Currently, I'm using Summit X460-G2-24x-10GE4 switch as Core switch and hope to add another Summit X460-G2-24x-10GE4 switch to the Core and Stack both switches. Currently core switch has only a few VLANs and few routing as configuration. I ne...
Hey, Can you validate that the following is a valid setup using MLAG. Sites A and B contain two MLAG peers each. There are two independent links between sites A and B, and in order to connect both sites, both peers can use MLAG at each end. (Each ...
Extreme switch is under TACACS authentication and I could not move from execution level (>) to configuration level(#) . see below commands and error Slot-1 NEOS-PS-FWswitch.6 > show configuration This user does not have permissions for this command...
I'm new to Network Administration but I'm working on configuring ACL's to allow two subnets to communicate with each other across two sites. Isolation needs to exist so hosts within the subnets can only communicate to each other and the internet. As...
Hi Guys, I've never applied and access list on Extreme Networks switches. I need to know how to apply a upload a ACL to a Black Daimond. I have about 10 VLANs I Need need: 1.- Permit all access on the same VLAN 2.- Permit all access to some serv...
