Hello! I have a question regarding a 670G2 best practices. I am replacing a undersized core with a pair of 670G2's in an MLAG config and VRRP to protect the L3 gateway. Is there anything special about the STP config for MSTP that is enabled by def...
hi everyone, i am currently testing the integration of exos switches in Solarwinds software (IPAM/UDT). In order to correctly assign MAC addresses to IP addresses, the following OIDs are required: ipNetToMediaTable = 1.3.6.1.2.1.4.22 ipNetToPhysical...
I have 2 of these Switches stacked on eachother. The top one is more under load most of the time and is currently running at 89F(31C) All 4 fans are between 8000RPM and 9000 RPM Why is it that they would be spinning at that rate? and why only this...
Scenario is: if all port A,B,C, are UP than enable port D If one of port A,B,C are Down do anything create upm profile MnLinkUp enable cli scripting IF (!$MATCH($EVENT.LOG_COMPONENT_SUBCOMPONENT,vlan.msgs) && !$MATCH($EVENT.LOG_EVENT,portLinkStateU...
Hi guys, I'm coming up ExtremeOS-VM over GNS3 using mpls and mpls-te under IS-IS, so, all routes are being received and sent to peers, however the interface tunnel is not getting up. So, in this scenario I was using OSPF where it was working fine, ...
