ExtremeSwitching (EXOS/Switch Engine) - Page 28 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Unbalanced load in sharing using algorithm address-based L3_L4 LACP.

Hello, On an X690-48x-2q-4c with EXOS 22.5.1.7-patch1-2, I have configured these commands. enable sharing 19 grouping 19-20 algorithm address-based L3_L4 lacpenable sharing 29 grouping 29-30 algorithm address-based L3_L4 lacp Although the source and...

Resolved! Error installing image - X435

Hi!I'm trying to update my X435 switch, but I'm getting this same error every time: * X435-24T-4S.17 # install image /usr/local/ext/32.6.2.68.xosDebug information files are present in internal-memory.These files will be removed if you continue with d...

Extreme 5320 -48-8XE had to break the stack from 5 to three due to switch reloads.

We have a stack of 5 5320s which started randomly reload and extreme GTAC recommended we break the stack to less than 3 which we have done and are now experiencing other failures. Has anyone else been advised to break their stack for similar reasons...

configure ip address

If I configure a port as breakout cable into 4 25gb lines does it need 4 ips per line or just one ip for the port

Resolved! Can't get a new 5400 to use SFP module uplink

I'm replacing an old Dell switch with a 5420M-24 with a fiber uplink. The old switch worked fine with it's SFP fiber connection but when I moved it to the 5420 I can't get the switch to talk to the network at all. I enabled Ethernet mode on the 5420 ...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN