ExtremeSwitching (EXOS/Switch Engine) - Page 32 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! EXOS iproute default not working as expected

Morning, I'm missing something in my setup and I can't seem to figure out what. Hoping one of you can assist.I have a WAN/LAN setup with the ISP.WAN is a /29 and acts as the gateway ip lives on the ISP devices.LAN is a /27 that the ISP routes to me v...

DHCP snooping on ports with dynamically assigned VLAN

Hi,To configure DHCP snooping in EXOS we have to configure it per port and per VLAN ie:enable ip-security dhcp-snooping vlan Example1 ports allenable ip-security dhcp-snooping vlan Example2 ports allBut when we move a port from one VLAN to another, D...

Resolved! X440-48t-10G switch, after a power outage, cannot load the configuration file when restarting XOS.

X440-48T-10G 交换机在断电后，重新启动 XOS 时无法加载配置文件。“show sw”命令显示使用的配置文件为“none”。“ls”命令显示配置文件存在于交换机中并且未丢失。使用“use config”命令指定配置文件并重新启动交换机后，交换机可以正常读取配置文件。使用“reboot”命令对交换机进行热重启后，交换机仍然可以正常读取配置文件。但是，当交换机处于正常工作状态时，通过拔下并重新连接电源线再次测试时，交换机在重新启动后无法加载配置文件。

Resolved! HOW TO CONNECT BETWEEN 2 or MORE VLAN

help, i just start learning networking. How to connect 2 or more vlan, for example i make 3 vlan (10, 20 and 30)vlan 10 is from port 1 - 5, vlan 20 is from port 6 - 10 and vlan 30 is from port 11 - 15and i want to access port 7 from vlan 20 when LAN...

Resolved! Would modifying an LACP sharing port cause an outage?

I have a 5 stack 5520 switch with 4 links to two X690's at the core. Its currently configured like so:enable sharing 1:57 grouping 1:57,2:57,4:57,5:57 algorithm address-based L3_L4 lacpWe are working on a switch consolidation project to reclaim swit...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN