ExtremeSwitching (EXOS/Switch Engine) - Page 31 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Error: Load sharing cannnot be enabled on ports

Hi,I have a 3 slot switch stack of X460G2-48p-10G4 switches. On this stack, ports 1:50 & 3:50 were shared so that there would be a connection to each of our two core routers. I removed slots 2 & 3 from the stack this morning. I wanted to reconfigure ...

Resolved! How do I configure a IP address on the mgmt port on a 4220-12P-4X

Hello Community,I'm new to Exos and I'm trying to figure out how to configure a IP address on the mgmt port on a 4220-12P-4X so I can use it as OOB Management and how can I verify that it is set?Thank you for the answers

Resolved! Facing Internet Connectivity issue in Extreme 4220 series.

Hi All,I have a network subnet with 4220 series switches internet working very well but suddenly I dont know from where I got a new dhcp server and I lost the Internet connectivity what type of security measures I should do to protect my switches fro...

Resolved! NPS and Extreme

Hello! I am trying to set up a service account that can read the config of our extreme and we authenticate it using NPS. I was wondering if anyone had any idea of how to do this? I tried messing with priv-level attributes but to no avail. I don't wan...

32.6.3.127 snmp compatibility

in older versions of EXOS we used the commands below to get our NMS working with interface stats. configure snmp compatibility get-bulk reply-too-big-action standardconfigure snmp compatibility ip-fragmentation allow these commands are no longer avai...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN