ExtremeSwitching (EXOS/Switch Engine) - Page 325 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Moving VLAN address definitions from Cisco To VSP - Retire Cisco - Error: Mulitnetting Not Supported

I am moving from Cisco to Extreme (VSP/ERS). I have a layer 2 connection between the Cisco core and the VPS "core". I have 5 VLANs (default gateways) defined on the Cisco and need to move them to the VSP. I remove the ip address from the Cisco (int...

EXOS SNMP access-profiles

Hi Community, There are many articles on the SNMP access-profiles; I have gone through few of them but could not find the answer to my specific queries.I have one snmp policy for "if match any" rules followinghttps://extremeportal.force.com/ExtrArtic...

Does X460-G2 need special config for snmp access?

Hi, We have a new building with one X460-G2 as core switch/router and many X440-G2 as edge switches. We started configuring and adding them to XMC. But X460-G2 does not come up in XMC. It does not respond to snmpwalk command also. We configure X440-...

Lousy, stupid, stubborn old radiology devices (and the Summit stack that hates them)

Howdy folks, I am trying to finish up a job replacing some very old Cisco 3750's with a new stack of Extreme Summit 450-G2 switches running ExtremeXOS version 22.5.1.7. I have four devices left that are giving me problems. One of them will only con...

Hello ! query ... an extrem SW supports more than one vlan in a port? Or should we eliminate the vlan to add another? Regards!

Hello ! query ... an extrem SW supports more than one vlan in a port? Or should we eliminate the vlan to add another? Regards!

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN