ExtremeSwitching (EXOS/Switch Engine) - Page 324 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

How do I remove current ELRP configuration to replace with new configuration

I have a number of X460 switches running 22.5. I want to change my ELRP configuration but I can not figure out the proper commands and I have been unable to find the answer on-line. There are lots of articles on how to configure it but none on how to...

EXOS VM (VMware ESXi): confuses MAC addresses

Hi, ARP requests carry the MAC address of the Mgmt port instead of Port 1 which is member of the VLAN I am using to try to ping something outside. This looks like a pretty basic fault that should not exist. So my question is whether I might be doin...

Multicast problem with dynamically created vlans

Hi, following scenario: - two AccessSwitchstacks X450-G2 (22.4), each connected with an MLAG to a pair of Summit X620 Distributionswitches. (X450 <=> X620 <=> X450) - VLAN A is configured in all Switches - VLAN B is configured in X620 and dynamically...

SNMP TRAPS for VRRP Status change

HI, i'm switching from a Cisco to an ExOS Network so i hav a lot of questions.. i want to sent a snmp Trap all vrrp status-changes. Is there e function at exos?

How can I configure both BGP for ipv4 and ipv6 on the same Extreme Layer 3 switches using XOS v16.2?

How can I configure both BGP for ipv4 and ipv6 on the same Extreme Layer 3 switches using XOS v16.2?

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN