ExtremeSwitching (EXOS/Switch Engine) - Page 344 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Does X460-G2 need special config for snmp access?

Hi, We have a new building with one X460-G2 as core switch/router and many X440-G2 as edge switches. We started configuring and adding them to XMC. But X460-G2 does not come up in XMC. It does not respond to snmpwalk command also. We configure X440-...

Lousy, stupid, stubborn old radiology devices (and the Summit stack that hates them)

Howdy folks, I am trying to finish up a job replacing some very old Cisco 3750's with a new stack of Extreme Summit 450-G2 switches running ExtremeXOS version 22.5.1.7. I have four devices left that are giving me problems. One of them will only con...

Hello ! query ... an extrem SW supports more than one vlan in a port? Or should we eliminate the vlan to add another? Regards!

Hello ! query ... an extrem SW supports more than one vlan in a port? Or should we eliminate the vlan to add another? Regards!

Looking for clarification on the enable iproute sharing command

Dear all, I used this command enable iproute sharing and then in routing table show tow routes but traffic one path so why ? Please tell me.

Can't set factory default or upgrade for summit x450a-48t

Hi, we are using summit x450a-48t with exos 15.3.2.11, recently, we want to reinstall or set factory default to it, but it didn't work. we used command 'unconfigure switch all' and reboot, but the old configuration is still there, we also confirmed...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN