ExtremeSwitching (EXOS/Switch Engine) - Page 355 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Can you preconfigure slot numbers on new switches going into an existing X450-G2 stack or do they have to be done at the time of install?

I have an existing stack with 2 nodes already. I am adding 3 additional switches to the stack. Can I preconfigure the 3 new switches as slots 3-5 before hand or will they need to be done once they are added to the stack as this article points out:htt...

Stacking with 440G2 while keeping "alternate" ports free?

Does anyone know if you can enable stacking on a 440-G2 (mostly for the possibility of future expansion and not having to renumber ports) but still use the alternate stacking (rear) ports as standard interfaces (in our case for an MLAG ISC instead of...

Private VLAN routing issue

I've configured a private VLAN for ports 1 and 2 so that they are isolated from one another. The configuration shown below is how I set it up, however, when I place a client on port 1 I can not ping the gateway.The client can ping the VLAN Mgmt99 IP...

Best practices for shared MAC on MLAG peers?

Creating an MLAG between two 440-G2's. The ISC will be an LACP of ports 15 and 16 and if I understand it, this LACP link must have a static MAC assigned on both sides of the ISC (on each peer). Is there a recommendation in terms of the MAC to use (do...

EXOS 22.5 "Creating Processes on Secondary Nodes"

One of new EXOS 22.5 Feature are this: "Creating Processes on Secondary Nodes" Changed CLI Commands Changes are underlined. create process name executable exe {start [auto | on-demand]} {nodenode} {vr vr-name} {description description} {arg1 {arg...

Top Kudoed Authors

User

Count

28

26

18

18

17

GTM-P2G8KFN