X670 link aggregation flapping problem suggestions
I have 2 x X670s connected with each other through a 10G x 4 aggregated port. Recently I have noticed that there is flapping of ports of this aggregated link. Any suggestions on why this may happen?
Forum Posts
DDMI information of X670/X670V
Hello Sir/Madam, I have Extrmem X670 and X670V switches in my DC. A few days ago,I used a LX transceiver from Extreme with my X670 switch to see the DDMI of this transceiver, but the switch didn't show the DDMI infromation, so did X670V. I know...
How to make 2 switches talk after connecting with fiber?
Hi First off, I'm very new to this, so please bear with me as I'm learning. I've tried to research this but I don't know the keywords I need. I have 2 Summit X250e-48P switches. I have managed to create a VLAN, set a DHCP scope, and connect devices...
Network redundancy in X-480 and X-670 G2 Series Switches
Hi, X-480 and X-670 G2 Series Switches support H-VPLS as mentioned in their datasheet. However, I am wondering if it support network (link or node) redundancy in case of any failure. How does the network participants (nodes) will come to know for an...
mpls over gns3 limitations
hello guys, I've been working over gns3 with EXOS_VM and some routers Cisco, so, I 'm struggling with mpls between them, which I would like to know if is it possible to exchange ldp and rsvp between them using gns3, or all configuration regarding mpl...
