ExtremeSwitching (EXOS/Switch Engine) - Page 449 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

ssh and telnet access

Hi Guys I am trying to setup telnet and ssh access on my extreme swicthes i ahve already tried the suggested solutions but they do not seem to help here is my configuration X440G2-48p-10G4.1 # sh configuration # # Module devmgr configuration. #...

ip forward-protocol from Enterasys syntax to Extreme

Hello Guy, how to translate these commands from Enterasys to Extreme 460? i haven't found the right command and no port on this so far. ip forward-protocol udp 2009 ip forward-protocol udp 3001 thanks in advance

X620 error log messages

Hello, all! Had an case 01280313 with X620 error messages. May be it can be usefull to add to GTAC knowledge base. Objective: Below error messages often appear IPv4 multicast entry not added. Hardware Group Table full. But debug hal show ipv4mc ...

EXOS specifiy source interface for sntp, download image or download url

We have a X450-G2 with 16.1.3.6. This switch is the router of a branch. Unfortunately the router-transfer nentwork is not part of VPN IPSec SA. So we have several problems with services which using the route-based source interface to reach some ser...

Firmware update question on 460's running VRRP

Hello, We have a pair of x460-G2's running VRRP and MLAG at two sites. They are currently running 16.1.3.6, and I would like to apply the current recommended firmware 16.2.2.4. This is the first time I have had to update the firmware while running...

Top Kudoed Authors

User

Count

28

26

18

18

17

GTM-P2G8KFN