ExtremeSwitching (EXOS/Switch Engine) - Page 455 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

In switch LAG , 1 port taking more traffic than others.

We have extreme inter switch with 7 ports in LAG all in different slots. And we can see 1 of the 7 ports is taking high utilization apart from other 6 As these on different slots, so any input on the issue. If anything can be checked...

invalid ssh key after config restore

Dear all. ssh is not working after restore a previously saved config. 1. save config new.cfg 2. unconfigure switch all 3. use configuration new.cfg 4 reboot The configuration is loaded successful and complete, but ssh is not working anymore. Conne...

Upm $EVENT.DEVICE mismatch when detecting and undetecting devices

I'd like to make a UPM script to configure the port parameters based on the connected device type (IP phone or access point). When the device is detected, the $EVENT.DEVICE variable returns GEN_TEL_PHONE or WLAN_ACCESS_PT. It is fine. But, when we di...

Unable to transfer pcap file via SCP

Hey there, I'm trying to transfer a pcap file from an X770 to my PC using SCP2 but I'm unable to do it. TFTP is not an option since it's unreliable and has failed multiple times during transfer. Tried also by connecting to the switch via SFTP but ca...

IPv6 forwarding issue with OSPFv3 in a user VR

Hi all Before I open a TAC case about this, I'm just trying to find out if anyone else is doing something similar and has the same issue. Somewhat simplifying, I have four devices physically connected like this: [ Cisco 1 ] -------- [ X460G2 "RX1"...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN