ExtremeSwitching (EXOS/Switch Engine)
Questions and discussions about EXOS
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! elrp-client on 5000 series?

So we are putting a bunch of new Extreme 5520's in and we use ELRP to detect loop traffic. I want it to log-and-trap so that our ExtremeCloud IQ site engine can send me an alarm and I would typically input the following command:configure elrp-client ...

OSPFv3

How to advertise default route to a OSPFv3 neighbor?In OSPF we use the command "enable ospf originate-default always cost 1 type ase-type-1" but I'm not finding a similar one to OSPFv3.

kennedydg by New Contributor
  • 755 Views
  • 1 replies
  • 0 kudos

e4g routing over e1?

We've previously used e4g's for pseudowires just passing a TDM circuit around via CES wires, but we now we're in a bing and need to bring up a circuit with IP services over TDM, does the e4g support this i can't for the life of me figure out the comm...

Chris1 by New Contributor
  • 321 Views
  • 0 replies
  • 0 kudos
GTM-P2G8KFN