ExtremeSwitching (EXOS/Switch Engine) - Page 486 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Can't do a firmware selection in Netsight

When I use the Firmware Upgrade Wizard in Netsight, I can't do a Frimware Selection. So I cann't map af device type to an image an upgrade the switch. I tested a couple devices (X440, X460) Version Netsight 7.0.9.4

Process hal died

Hello community, Two adjancies switchs rebooted signalling that the process died. The first one said: 02/04/2017 09:14:07.07 Connection lost with process hal02/04/2017 09:14:00.90 2cf66824 0320f809 jalr t9 02/04/2017 09:14:00.90 2cf66820 000...

Serial number to part number

I am working on our support renewals and I need part numbers( I already have all of the serial number). I know when I open a TAC case it automatically identify the part number once I enter the serial number. I am looking to do that with a large li...

Cisco Phones Receiving DHCP IP from wrong VLAN on EXOS switches with Cisco Router DHCP

I have an X430-24p running 15.5.3.4. The switch runs to a Cisco router that has DHCP running on it. Voice and Data VLANS were configured on the switch and router. Ports are configured with the Data VLAN untagged and the Voice VLAN tagged. The trunk ...

Cisco 7945G is not pulling the correct voip-vlan as advertised with CDP

I know that this is a common question, so don't punch me. I am only asking because there is new firmware since the last time this was brought up. In the past I have used lldp to advertise the voice VLAN tag to my Cisco devices. That works! But it do...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN