ExtremeSwitching (EXOS/Switch Engine) - Page 492 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

EXOS create lag for 2 switches

I have 2 new EXOS switches (X620-16x) that are going to be used for ISCSI traffic for a Nimble SAN. I am new to EXOS and I am still learning EOS so I'm new to all of it. The Nimble device recommends that the switches are "trunked" together and that...

ospf stuck in init state

ospf v2 created on 2 BD switches for communication between BD switch and Node. Point to point works okay on one BD, but didn't work on other BD side stack its in INIT stage while on Node end its is completely down. All configuration verified and ob...

How to delete part of an OSPF command in the Config

I have a couple lines in my OSPF config that i cant seem to remove. i am trying to get rid of this: configure ospf vlan VLAN_0009 priority 0 i have tried "unconfigure" command which doesnt work. not sure what else to use.

AVDECC Entity Available not sent

Dear Experts, I have a Summit X440-8t AVB switch. I am running AVDECC on two devices connected to the switch. One device is AVDECC Controller, the second device is AVDECC Listener. When I run the Listener, I can see that it sends ADP Entity Available...

Too many ACL's & packet rate is too high issue

Hi, When i configure the switch to download Xos image to upgrade its verson im getting too many "Too many ACL's & packet rate is too high" messages in the switch logs. 02/24/2017 11:34:27.76 Slot-1: Denied packet on ingress interface vlanIf=1000010...

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN