ExtremeSwitching (EXOS/Switch Engine) - Page 53 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

DHCP snooping on ports with dynamically assigned VLAN

Hi,To configure DHCP snooping in EXOS we have to configure it per port and per VLAN ie:enable ip-security dhcp-snooping vlan Example1 ports allenable ip-security dhcp-snooping vlan Example2 ports allBut when we move a port from one VLAN to another, D...

Resolved! X440-48t-10G switch, after a power outage, cannot load the configuration file when restarting XOS.

X440-48T-10G 交换机在断电后，重新启动 XOS 时无法加载配置文件。“show sw”命令显示使用的配置文件为“none”。“ls”命令显示配置文件存在于交换机中并且未丢失。使用“use config”命令指定配置文件并重新启动交换机后，交换机可以正常读取配置文件。使用“reboot”命令对交换机进行热重启后，交换机仍然可以正常读取配置文件。但是，当交换机处于正常工作状态时，通过拔下并重新连接电源线再次测试时，交换机在重新启动后无法加载配置文件。

Resolved! HOW TO CONNECT BETWEEN 2 or MORE VLAN

help, i just start learning networking. How to connect 2 or more vlan, for example i make 3 vlan (10, 20 and 30)vlan 10 is from port 1 - 5, vlan 20 is from port 6 - 10 and vlan 30 is from port 11 - 15and i want to access port 7 from vlan 20 when LAN...

Resolved! Would modifying an LACP sharing port cause an outage?

I have a 5 stack 5520 switch with 4 links to two X690's at the core. Its currently configured like so:enable sharing 1:57 grouping 1:57,2:57,4:57,5:57 algorithm address-based L3_L4 lacpWe are working on a switch consolidation project to reclaim swit...

Resolved! optical threshold on X620-16x

I want to change the optical threshold (RX Power) on the tranxceiverHow can I do this ?

Top Kudoed Authors

User

Count

32

29

20

20

17

GTM-P2G8KFN