ExtremeSwitching (EXOS/Switch Engine) - Page 552 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Negotiating Ethernet and VLAN Interworking Types in VPLS

X670 connected to other VPLS capable device who can't use manual settings for vc type. When created pseudowire with tagged type, connection stay down and in dump we see label mapping messages with VC type 0x0004 (Ethernet VLAN) from other device and ...

How to make ACL that will only allow HTTP traffic to and from a specific host

I am new to ACL in Extreme and would like to seek your support on how to make an acl to only allow HTTP and HTTPS traffic to and from host 10.158.22.36. All other packets to and from 10.158.22.36 should be denied. thank you!

How to configure a port of the switch SummitX-150 to connect a vmware infrastructure with several machines on differents VLANs

I'm configuring a switch Extreme SummitX-150 Port to connect an ESXi platform on its port linked to a vswitch. the vswitch has several VMs on differents vlans. How to configure the Switch Port? Previously the switch used was a cisco 2960 and the conf...

Field Notice (FN412) - EXOS 21.1.1 Patch 1-2 will not forward traffic with default configuration

The Extreme Networks Services Team has posted a new Field Notice on the GTAC Knowledge website. FN412 - EXOS 21.1.1 Patch 1-2 will not forward traffic with default configuration on the GTAC Knowledge websiteThis notice is of particular interest to cu...

Adding GNS3 options for using EXOS-VM

Hi again, Drew! I sent the link to this thread to the two GNS3 devs (Jeremy and Julien), but they're pretty busy guys, so I don't know how long it'll be before they jump into the discussion. I don't know if you've ever checked out GNS3 (here's the...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN