ExtremeSwitching (EXOS/Switch Engine) - Page 56 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Trouble to get 100BASE-X SFP to work on X465-24s

Hello community,I'am using 2 x456-24s Extreme Fiber switches. I've read that those switches should support 100BASE-X, but in my case they wont.I think maybe i have wrong SFP modules - i have tried EDGE sfps (i've had positive experiences between edge...

Stack shows config changes pending after reboot....

Stack of two 5420F-48P-4XE running 31.7.1.4 - brand new setup, new config. If I save the config (successful save, no issues), then reboot the stack, upon login the CLI prompt shows* Slot-1 4th-stack-new.2 #as if there's a config change pending (the ...

Why am I not seeing the DHCP Offer or Ack packets from the DHCP server on the mirror session?

I have a problem. I've got an X460-48p which I am doing a port mirror session on, aiming to capture some DHCP traffic to troubleshoot an issue. I am aiming to capture traffic between a source PC and a destination DHCP server. I have set the mirror co...

Resolved! Help creating MLAG to 2 x X670V switches using a single 10GB port on each

Hello,I've got a VMware Host with 2 x 10Gb going into 2 X670V switches (1 port in each) where I set them up as a MLAG (LACP). I've done this before and the port on the switches are usually the same, for example if it's port 10 on both switches I wou...

Resolved! Stacking port order question

Hello,I have created a stack of 4 x440-48p g2 switches using the alternate stacking ports. The switch stack is in production and is working, but I realized afterwards that while wiring the stack up in the rack I did the stacking ports exactly opposit...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN