ExtremeSwitching (EXOS/Switch Engine) - Page 616 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Single EAPS ring, master node in INIT fail time-out

Master node goes in INIT status fail time out. I have a single ring with a correct VLAN data mapping, VLAN control and no storm(broadcast). If I use specific ports master node goes in Complete or Failure(if rings open) and It means that PDU for Heal...

upgrade XOS from 15.1.4.3 to 16.1.3

Dears, we have in our network BD-8810 with the release 15.1.4.3 and we would like to upgrade it to 16.1.3. can we do a direct upgrade or is there another recommended way of doing it? Thanks Sal

ERPS - switch stuck in pending state

Hello Hub Community, I have an issue with an ERPS-based network topology composed by 4 switched. The 4 switch are connected in a squared topology: SW4 -- SW1 | | SW3 -- SW2 Basically, SW1 is the RPL owner and SW2 its neighbor. Th...

EXOS: STP on MLAG ports

Are there any plausible reasons why STP is not possible on mLAG ports ? For a current network project is would be very useful if i can use STP on core layer links (where 2 links are bonded with mLAG).

Is there an unzip command on ExtremeXOS?

I have a telnet connection with my switch using a C++ program I've written. I then have to upload 300-350 .xsf scripts to the switch using tFTP. The problem I have is that uploading the scripts takes around 2 minutes. In other sections of my code I h...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN