ExtremeSwitching (EXOS/Switch Engine) - Page 617 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

ERPS - switch stuck in pending state

Hello Hub Community, I have an issue with an ERPS-based network topology composed by 4 switched. The 4 switch are connected in a squared topology: SW4 -- SW1 | | SW3 -- SW2 Basically, SW1 is the RPL owner and SW2 its neighbor. Th...

EXOS: STP on MLAG ports

Are there any plausible reasons why STP is not possible on mLAG ports ? For a current network project is would be very useful if i can use STP on core layer links (where 2 links are bonded with mLAG).

Is there an unzip command on ExtremeXOS?

I have a telnet connection with my switch using a C++ program I've written. I then have to upload 300-350 .xsf scripts to the switch using tFTP. The problem I have is that uploading the scripts takes around 2 minutes. In other sections of my code I h...

Multicast routing between VRF's

Hi! I wondering if it's possible to route incoming multicast from one VR to another VR in the same machine? The reason is that I want to isolate a PIM domain for our IPTV customers from our core network. A simple solution would be to do a loop in t...

Config Port Redundant

How do i config port redundant from one x670 to another x670 or in my case a juniper MX ? is it enough to only config the extreme side with "configure port 1:1 redundant 1:2 link off" or do a have to config some redundancy on the other side to (MX)? ...

Top Kudoed Authors

User

Count

33

29

22

20

17

GTM-P2G8KFN