ExtremeSwitching (EXOS/Switch Engine) - Page 729 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

lacp load balancing with mpls

I've experience a problem where i have a topology networking in ring and all switch is set up mpls with lacp. So the problem is the lacp doesn't work in mode load balance with mpls, other words, when i put 2 ports (port 1 and port 2)interface in mo...

Dot1p configuration

I am totally new to extreme. I am configuring Qos based on dot1p. I configured the dot1p and QP mapping. But the switch cannot detect any CoS 802.1 value at all . all traffic go to qp1. is there anything I have to do other than maping this cos to...

So many TXerror

Hi, Why would i been receiving error on Txerrors. Tx coll and Tx Deferred, should they not be the same count if the collision occurs and the packet is deferred? Port Tx Error Monitor Port Link Tx ...

During Upgrade BD 8K Switch from 15.1 to 15.3 while TFTP having Error: File could not be unwrapped.

Hi Team , We are going to upgrade BD 8K Switch from 15.1 to 15.3 , At starting of upgrade while doing TFTP of image file we encounter problem of FIle could not be unwrapped . Then we try to download fresh image & tried again but same issue . ...

Failed to download image - Error: File could not be unwrapped

I am trying to download a new image to Summit X460-24p and I get the below error # download image memorycard summitX-15.3.4.6-patch1-5.x primary Downloading to Switch.............Error: Failed to download image - Error: File could not be unwrapped....

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN