ExtremeSwitching (EXOS/Switch Engine) - Page 745 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

EAPS and oneway traffic

Question around oneway traffic patterns in a ring design Say I have a ring of 4 switches interconnected with WDM equipment over dualfiberpairs Between switch 1 and 2 I loose the link, so the switch flags the port as down Local fault. However th...

Gateway address of the switch

Hello, Normally on Enterasys Networks we can write, set ip address 10.0.0.98 mask 255.255.255.0 gateway 10.0.0.254 but in new Extreme Networks we can not write that gateway address. Therefore, where should we need to define that gateway address an...

EAPS Pros and Cons

Greetings .... I am ramping on XOS features and functionality in order to sandbox a Dev/Ops infrastructure migration project that relies heavily on shared network services using management VM's and VLAN's. Would like to solicit Pros and Cons deplo...

EXTREME-BASE-MIBs/extremeBfd

Hi, I'm looking for EXTREME-BASE-MIBs, especially I'm interested extremeBfdSessDown notification OID. I stuck with the extremeBfd. Thanks in advance, A.

show ports qosmonitor

Hi all, We're implementing QoS on 6 switches - 4 BD8810 and 2 X480, SW version is 15.2.1.5 The configuration is as follows: configure vlan qosprofile qp6 enable diffserv replacement ports configure diffserv replacement qp6 code-point 46 Then we ...

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN