ExtremeSwitching (EXOS/Switch Engine) - Page 93 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! EXOS dynamic ACL on VLAN not working.

Hi, I want to permit selected subnets and deny all other subnets ingress traffic to our PBX vlan. I configured ACLs shown below. But I can still access to PBX VLAN (web pages of IP phones on PBX VLAN) from every where. What shoul be the problem? PB...

Resolved! swtich rebooted due to mpls problems

Hi, i have a problem with mpls. After i had it configured, switch was rebooted with message:<Warn:DM.Warning> Switch FAILED (1) Process Failure09/29/2021 21:44:12.42 <Erro:DM.Error> Node State[4] = FAIL (Process Failure)09/29/2021 21:44:12.42 <Warn:...

WoL Wake on LAN to routed remote location

Hello,I’ve a customer with routed remote-locations via MPLS.Wake on LAN on the main location is working fine (upd-profile with match-criteria to 3 source-IPs, dst-broadcast-mac and dst udp port)To get WoL running on the remote-location (also routing ...

Resolved! Alert on Auth Fail

I am look for a way to send an alert upon a failed login attempt on a switch running EXOS version 30. When I set out to do this, I thought it would be fairly straight forward, however my search has been fruitless. Is this even possible?

Resolved! clear config in 1 section/chapter

Hello,is it possible to clear the hole config / set to default in 1 dedicated section/chapter (e.g. snmp)?I’ve switches with a lot of different configs in individual sections. I’d like to clear this individual sections and put same config to all swit...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN