ExtremeSwitching (EXOS/Switch Engine) - Page 94 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Lost of OM connection to Switch

Dears , I need an explanation on why i could lose a remote management (OM) connection to my switch System Type: X480-24xAfter I implemented the command below to create a lag group to my Routerenable sharing 1 grouping 1, 3 algorithm address-based l...

Command conversion for CISCO to Extreme XOS

Hi Extreme Team, Please let us know is there any command conversion tool is available for converting Cisco command to Extreme EXOS.?

Resolved! EXOS switch shown as "Fabric/FA Server" in XMC fabric topology

Hello,I added a new ExtremeXOS (X440G2-48p-10G4) switch as fabric attached device to my fabric.But inside the "XMC fabric topology " map the EXOS is shown as "Fabric/FA Server" (all other EXOS are shown as "FA Proxy/FA Client").What am I doing wrong?...

X440-G2 10GB Uplink - bad snare if you miss 10GB LIC

Today we have a very painful and time-killing problem. Be careful NOT to run into the same issue. We using X440-G2 with 10GB GBICs on the Uplink ports (51-52 - with Dual 10GB LIC) linked to 2x X670-G2 also with 10GB GBICs. Some of my collegues conf...

Resolved! Simple Question About Port Numbering on the X460G2-48p-10G4

Looking at the front of the X460G2-48p-10G4's you can see they have: 48 x 10/100/1000BASE-T PoE-Plus 4 x 10GBASE-X SFP+ (unpopulated ports) This makes for a total of 52 ports that I would expect to see on the CLI. But oddly, when I issue a show po...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN