ip forward-protocol from Enterasys syntax to Extreme

[Gradelain_Ngoun]

Hello Guy,

how to translate these commands from Enterasys to Extreme 460?
i haven't found the right command and no port on this so far.
ip forward-protocol udp 2009
ip forward-protocol udp 3001

thanks in advance

[Gradelain_Ngoun]

for those facing the same issue, i used this guide here:

http://documentation.extremenetworks.com/exos/EXOS_21_1/IPUnicast/t_configure-udp-forwarding.shtml

[Gradelain_Ngoun]

thanks a lot. issue solved. regards

[OscarK]

UDP profiles should be used for that, assuming it is udp broadcasts to these ports.
https://gtacknowledge.extremenetworks.com/articles/Solution/UDP-broadcast-packets-are-dropped-by-EXO...

[Gradelain_Ngoun]

my goal is to allow some ports which are not allowed by Default...
following is already implemented:
""""
configure bootprelay add vr VR-Default
enable bootprelay ipv4 vlan
"""""
what is missing is to allow the relay over UDP port 2009 and 3001.
Any help is appreciated.

Thnaks