Dear Extreme,
One of the ports on our X450G2 stack is showing up as enabled and active. However when we want to see the mac address of this port, nothing is being listed?
How is this possible? How can we figure out the mac address of this port?
Slot-1 LANSTACK.45 # show port 2:13 no
Port Summary
Port Display VLAN Name Port Link Speed Duplex
# String (or # VLANs) State State Actual Actual
===========================================================================
2:13 PCs PCs E A 10 FULL
========================================================================
Slot-1 DCK-LANSTACK.47 # show fdb port 2:13
MAC VLAN Name( Tag) Age Flags Port / Virtual Port List
------------------------------------------------------------------------------------------------------
These are the details of our stack:
SysName: LANSTACK
System Type: X450G2-48p-10G4 (Stack)
SysHealth check: Enabled (Normal)
Recovery Mode: All
System Watchdog: Enabled
Slot: Slot-1 * Slot-2
------------------------ ------------------------
Current State: MASTER BACKUP (In Sync)
Image Selected: primary primary
Image Booted: primary primary
Primary ver: 30.7.1.1 30.7.1.1
patch1-103 patch1-103
Secondary ver: 30.7.1.1 30.7.1.1
patch1-103 patch1-103
Config Selected: primary.cfg
Config Booted: primary.cfg
