OSPF Init stuck

[Julian_Eble]

Hello Community,

I'm in a odd journey trying to understand what's going on here.
There are two Extreme switchs connected by 2 10G ports running LACP.

The master port is UP and the member also is UP and everything is okay with LACP and OSPF between them.
But if the master port is disabled, the OSPF get stucked into Init state.

I tried to took off the port from the sharing and tried to solo running the ospf , but it didn't worked.

The stranger thing here is if that member port is in the sharing group it ran fine, without any loss.

What should I do? Any advices?

Thanks 

[Daniel_Coughlin]

perhaps it would help to post The relevant parts of the configuration?
perhaps tracing on both sides to make sure the hello's are seen at the port level then work up the stack from there?
Of course the GTAC is available as well as the fine folks on the HUB.

[Julian_Eble]

Hey there,

So I'm using the version 16.1.3.6 16.1.3.6-patch1-11.

Now the port isn't on the LACP and the OSPF is not getting up.

Also did the clear igmp command to test but nothing happened.

[Necheporenko__N]

Hello Julian,

The issue looks like known bug - https://gtacknowledge.extremenetworks.com/articles/Solution/Local-multicast-traffic-is-not-egressing...

Best Regards,
Nikolay