cancel
Showing results for 
Search instead for 
Did you mean: 

X440-48p switch does not boot till unplug and plug the power cable

X440-48p switch does not boot till unplug and plug the power cable

Husam
New Contributor II
I have a setup of more than 100 X440-48p switchs firmware 15.6.4.2.

There are two switches which (if the power cut off and return back) do not boot till unplug and plug the power cable.

Is there any advice!

Thanks in advance.
2 REPLIES 2

Ryan_Mathews
Extreme Employee
Wow....thanks for deploying 100+ Summit X440(s) Husam!

GTAC will help you get to the bottom of this.

Karthik_Mohando
Extreme Employee
Hi Husam,

I would suggest to open up a ticket with GTAC on the same, you can provide the "show tech" for initial analysis.
GTM-P2G8KFN