Possible to stack x480-48t with a x620-16X?
I have an x480 that I want to add multiple 10G ports to. Is it possible to stack this with a x620-16X? If yes, what modules would I need to add-on/buy for both switches?
Forum Posts
Summit Boot Up Error Messages: KICM: bcm_linkscan_register failed for unit 1, error -3!
Hi Everyon,We have been running the summit x460 for almost 4 years in a stack and suddenly that one from that stack comes down, and we weren't able to start up it again, and when we put the serial cable to indentify what was going on with that we cou...
2017-04-24: New GTAC Knowledge Articles April 16 - 22, 2017
Here are the new articles that were published April 16 - April 22, 2017 in GTAC Knowledge: Sunday, April 16, 2017: S-Series card reset with message "Magmalite detected fatal condition" Monday, April 17, 2017: The status LED on I/O module got stuck ...
Compatibility Matrix for Firmware
Hi, I am looking for the compatibility Matrix of Firmware for the A2 Series & S4 Series. Anyone can share the path from where I shall get it?
enable sharing 1:2 grouping 1:2 1:3 lacp
Does it mean active active or. Active passive...... As far I can understand I am assuming 1:2 will be primary link on which all traffic will pass, and 1:3 is standby and used only when 1:2 fails ...... Any one can correct me.....
