ExtremeSwitching (VSP/Fabric Engine) - Page 4 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! VSP8404C System Uptime Resets After Every 497 Days ?

Hi SirsWe have encountered VSP 8404C after 497 days, the system automatically rebootedWe also searched related KB and found that the following models describe why this problem occursEthernet Routing Switch 4500 running any supported software versionE...

Resolved! LACP Key Mismatch Issue Between Extreme 7520 VOSS and HPE 8360 VSX Switches

I am experiencing an issue with LACP key mismatch between my Extreme 7520 VOSS switches and HPE 8360 VSX switches. Here are the details of my setup and the problem:Setup:Extreme Switches: 2 x Extreme 7520 VOSSHPE Switches: 2 x HPE 8360 VSXLACP Config...

Decommission switches to redeploy on another site.

Hi Hope someone can advise. If there is any recommended method for decommisioning Edge switches from one fabric network to another.Is it simply a matter of wiping the switch after removing from Network A and reconfiguring for Network B ?I know this s...

Resolved! LAG vlans and core port vlans

Hello Everyone,Quick question - I have come across a couple of LAGs on my 8400c switch. I can see the vlans associated with the lags.However, on the uplink port to the core switch, the vlans are not the same as the LAG vlans.Can anyone help me unde...

Resolved! Do Not Fragment bit in Fabric Engine 'Ping'

HiI want to test MTU between two Fabric Extend endpoints both running 9.0.4 that traverse a third party network where the third party does not always set the path MTU to allow FE (it's usually 1900 end to end).I'm pinging from the tunnel interface on...

Top Kudoed Authors

User

Count

35

18

18

18

8

GTM-P2G8KFN