ExtremeSwitching (VSP/Fabric Engine) - Page 6 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Decommission switches to redeploy on another site.

Hi Hope someone can advise. If there is any recommended method for decommisioning Edge switches from one fabric network to another.Is it simply a matter of wiping the switch after removing from Network A and reconfiguring for Network B ?I know this s...

Resolved! LAG vlans and core port vlans

Hello Everyone,Quick question - I have come across a couple of LAGs on my 8400c switch. I can see the vlans associated with the lags.However, on the uplink port to the core switch, the vlans are not the same as the LAG vlans.Can anyone help me unde...

Resolved! Do Not Fragment bit in Fabric Engine 'Ping'

HiI want to test MTU between two Fabric Extend endpoints both running 9.0.4 that traverse a third party network where the third party does not always set the path MTU to allow FE (it's usually 1900 end to end).I'm pinging from the tunnel interface on...

Assistance with OSPF config for default route

I need help with VOSS configs to add the default route. Here's the config from a cisco box but need help converting it to VOSS codeCore Switch Configuration# Enable OSPF process 1router ospf 1router-id 1.1.1.1network 192.168.1.0 0.0.0.3 area 0 # Adv...

Resolved! show ip dhcp-snooping binding summary is blank

I don't know how to get this command to populate any information. We are using 5320's on VOSS 9.0.3.0. DHCP Snooping says its enabled and the ports all say untrusted. I have clients connected but table is blank. What am I missing? Thanks so much.

Top Kudoed Authors

User

Count

36

19

18

18

8

GTM-P2G8KFN