AP460c not powering up on 5420F-48P

[dabbler]

I have installed a new switch stack with 11 AP305c's and 3 460c outdoor APs. None of the 460c APs are booting up, but a 305c boots up no problem on the same cabling.

I've made sure inline power is enabled is max output is 30W but now I'm stuck. Any ideas?

[Christoph_S]

Check to see if this will help: https://extreme-networks.my.site.com/ExtrArticleDetail?an=000114196

BR,

[dabbler]

Will do Christoph. It's a remote site so I'm not sure when I'll be heading out. Thanks a lot!

[Christoph_S]

SSH into the AP305C and run the following commands:

show system power mode

Show system power stat

This will tell you if the APs are operating in 802.3AF or AT power. If operating in 802.3af power, then there is your issue, the AP460 need AT power. You'll have to go back to the switch to check the settings but before doing that you can also run the following command on the AP305C:

show lldp

of lldp is enabled then your settings are correct but if not then you'll have to enabled lldp in the network policy and make sure that the  "Enable LLDP on access ports" box is checked:

[dabbler]

LLDP is enabled ok. I run the 2 commands the next time I'm out at the site:

show system power mode
show system power stat

Is there a command to force 802.3AT on a switch port?