Hi Community
So I have a question for the community and would like to get your comments on the topic.
I have been deploying the solution for years now (From when Enterasys started with the product).
When I do the initial configuration of the controller, I usually configure the AP's default settings to Auto select the Channel for both 2.4Ghz and 5Ghz.
With the various code releases "Dynamic Channel Selection" was introduced, some version setting this to Monitor only and other version setting this to Active Mode by default.
The question I have is that at most of the deployments across the years I have seen that the AP's would all place their channels on both the 2.4Ghz and 5Ghz on the same channel.
I usually end up with statically assigning Channels to avoid the same channel selection.
I understand that I might have outside interference cause all the AP's to try and hog the same channel.... But I have seen other systems deployed in the same space and the channel selection was perfect, every AP on it own unique channel.
What have you experienced on this, lets discuss your experience regarding this matter and your recommendations.
Regards