Network Architecture & Design - Page 12 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

Resolved! How many V400 on VX-RPS-1000

Hello, we want to setup V400 switches with a VX-RPS-1000. What ratio does the RPS serve? Is it a 1:1 per V400 switch or can I connect more than one switch to the RPS? We will be using VX-RPS-CH3 to host the VX-RPS-1000 but need to determine how many...

help for configuration AP7131

Hello, I have problème with my ap7131. I would like to use the DCHP of my zyxell for the connection, but my ap7131 blocked the DCHP. i have try to connect my phone is ok, but with the MC9060 or PDT6846 is blocked to the connection. someone would have...

How to block the communication between the hosts in same subnet...

Hello, We are having a VLAN with the IP Range 10.1.2.x/24. We need to block the intercommunication of hosts in this subnet. The hosts in the subnet can only reach the Gateway 10.1.2.1 only. Please share the provisions to enable this.

Failover between two DC's

Hi Folks, I currently have 2 DC's that are in the same geographic region along with several remote sites. All locations are connected via private Metro-E service with L3 connectivity (OSPF). I am considering running iBGP w/OSPF redistribution to s...

OSPF over GRE tunnel, how?

Hello, I have a juniper router in DC1 and extreme x480 in DC2. Between DC1 and DC2 made GRE tunnel. How to run OSPF over GRE tunnel on extreme device to redistribute ipv4 routes? IMG: 15.5.4.2 Thanks.

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN