Hello Aleksandr123, to check what acutally is ongoing, you can use the service commands on CLI on your AP and then visualize the traffic. E.g.: service pktcap on interface vlan 1 , or service pktcap on bridge...etc...Please use "?" to see options, li...
Hello, this will not work. Below lines are taken from the legacy Installation Guide of the AP 6521:"Virtual Controller AP - When more than one Access Point is deployed, a single Access Point canfunction as a Virtual Controller AP. Up to 24 Access Poi...
Hello, if that is the case, then please enter this line into every given RF Domain : "control-vlan 1" , But be carefull....Are all 3 given RF Domains local or remote to you? if they are local, then you might need "Area IDs"...as all the Mint Level 1 ...
Hello , on the given 3 RF Domains, what is the assigned "Control VLAN" ? It seems, that there is none....Can you please double check...The control VLAN is an assigned VLAN Number, on which the APs can communicate on Mint Level1 to elect their RF Doma...
Hello,in order to check, that the new APs are really in the same RF Domain, issue an "show global domain managers" on a CLI / SSH session....When all is OK, there should be 1 RFDomain Manager and the rest should be the total amount of your APs.Are yo...
