Extreme Networks

XTRMUser · 11-15-2024

Running VOSS 8.10. Stream goes through our router (VOSS), so the vlans have IP address on the switch/router. The path takes the stream to another VOSS switch, with no IP address on the vlan. So, theoretically, I should use "mvpn-isid 0" (to use the G...

XTRMUser · 02-28-2024

I have a couple of workflows that take time to run (one is about a minute, the other is a few minutes). Is there some way I can have an update showing on the screen to say it still running? Both of these workflows traverse all the switches, so switch...

XTRMUser · 02-27-2024

I'm working on developing a workflow that will show where a mac address is in my network. I can't query XIQ, since a number of the mac addresses aren't there, and I don't have the IP address and use "show ip arp <ip address>" on the VOSS cores.In my ...

XTRMUser · 01-04-2024

Currently we use DHCP options for setting up our Avaya phones (mostly 9600's and J100's). It works, usually, and was wondering if LLDP would work better.I've seen examples/docs for setting up EXOS, but not ERS. So some help would be appreciated. Read...

XTRMUser · 11-17-2023

I have two VOSS cores (routers, vISTed), some other VOSS switches (Top of rack, etc), no EXOS, and number of ERS. I know that ERS can't handle ACL's.My question is. To have effective ACL's (throughout the network), do I need to put them on each VOSS ...

XTRMUser · 10-16-2024

I think WillyHe did a good job of explaining what you need to do. In our situation, all the switches (Cores and TOR's) are VOSS, which is why we did what we did.

XTRMUser · 10-15-2024

I think your cores are running VOSS correct? What about your TOR's?

XTRMUser · 10-15-2024

We have a similar setup. In ours, our two Cores are vIST'ed together. Then on each site, our two top of racks (running VOSS) are vISTed to each other. Then from site A, there is an uplink to Site A core, and one uplink to Site B core. You can either ...

XTRMUser · 06-26-2024

You mentioned fiber with SFP's. In my experience, you disconnect the fiber and then pull out the SFP. I wonder if you got some dirt, and need to clean the SFP and fiber ends. I don't know if you use EDM, but if you do, check for errors on the SFP por...

XTRMUser · 04-09-2024

I'm not aware of any built-in methods to do this.The easiest way (as far as I know) is to use XIQ-SE. I think some routine that can start a CLI session (putty or equivalent), and insert commands into that CLI session (I don't know if putty can do thi...

Extreme Networks

User Statistics

User Activity

VOSS Multicast across vlans, mvpn and IP Shortcuts multicast

WorkFlow question

Workflow emc.cli question(s)

ERS switch (4800, 4900) and LLDP for Avaya VOIP phone

Filter ACL's on VOSS, how far reaching are they?

Re: Extreme core switch and Top of rack switches

Re: Extreme core switch and Top of rack switches

Re: Extreme core switch and Top of rack switches

Re: Swapping fibres in VSP SMLT to EXOS LAG = SMLT port down

Re: how to set up automatic saving of switch configuration on VOSS switches