ExtremeCloud IQ- Site Engine Management Center - Page 151 - Extreme Networks

ExtremeCloud IQ- Site Engine Management Center

Questions and discussions about ExtremeCloud IQ-Site Engine Management Center

Forum Posts

Sorted by:

Start a conversation

Configuration Evaluation Tool Issue

I found an issue with newest version of XMC - Version 8.2.4.42. Configuration evaluation tool (WEB) does not interpret properly location data from wireless. Below you can see screenshot from legacy java version and web version – difference is in fie...

how to change country allocations

I´m buidling a Netsight System with different locations. unfortuanally some locations using "wrong" Ip Addresses becaus of historical reasons ... its not possible to change these addresses becaus there are large networks behind them. The Problem is ...

Flexview that show at most 11 ports

Hi...I created one group of 16 ports and I have started my flex view to show the amount of time the 16 ports are UP. The result is that I see only 11 ports if I use any other original flexview I see all the 16 ports Can any one help me??

XMC - Launch WebView device option

Hi folks!!! When I try open GUI to VSP from XMC DEvice tab (View --> Device details --> Launch WebView) it doesn´t open. I capture traffic and see that XMC try to redirect me to http port 80, but my devices are configure in secure option, only all...

XMC APC-UPS-Traps config

Hello, I need alarms in XMC from APC-UPS-Traps. I added this to trapd.conf: OID_ALIAS apc .1.3.6.1.4.1.318 EVENT upsDiagnosticsPassed .1.3.6.1.4.1.318.6.10 "Status Alarms" Warning FORMAT upsDiagnosticsPassed: $1 SDESC Test!!!!!!!!!!!!!!!!!!!!! I...

Top Kudoed Authors

User

Count

82

75

39

17

16

GTM-P2G8KFN