ExtremeSwitching (EOS) - Page 6 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

Heads Up- EOS Firmware to be Removed from the Extreme Portal April 2nd, 2024

Due to third party software restrictions, as of April 2, 2024, Extreme Networks will remove all EOS software revisions noted in the ‘Software Affected’ section below from the Extreme Support Portal and will no longer distribute any software revisions...

STP Configuration Question

Hi All, I am new to Extreme switching and currently looking to replace existing ICX6450-48P Edge switches with the 5420 models and need to know best practice for configuring these Edge switches with STP before connecting them to the network with othe...

ExtremeXOS migration to Cisco 9000

Hello Folks, said to see Our ExtremeXOS Black Diamond 8810 goes, but time to refresh comesI have a (BD-8810) version 16.2.4.5 1 and we want to migrate to Cisco Catalyst series, In addition to the Running config that I collected already, could you pl...

how to configure Spanning Tree Configuration on Two redundant extreme switches ?

Dear Gentsi have two extreme switches which i need to configure spanning tree on them to prevent looping could you help me in configuring themboth switches will have the same configuration and will be connected together physically using port 17,18 tr...

IGMPv2 querier election issue

Hello,I'm new to the multicast protocol. On my switches, the igmp snooping is enabled per-port, version 2, on all of them. I have several vlans configured on the switches.I set on one switch an IP on vlan29, and I have an IP on the management vlan. S...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN